Xerox 7232 Manuel d'utilisateur télécharger pdf (Page 118)

9 TCP/IP (LPD or Port9100)

108 Xerox WorkCentre 7232/7242 System Administration Guide

When [IPv4 Mode] or [Dual Stack] is desired:

1. In [Connectivity & Network Setup], select [Protocol Settings].

2. Under [TCP/IP - IP Mode], select [IPv4 Mode] or [Dual Stack].

3. Select [IP Address Resolution], and then [Change Settings].

4. Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],

[DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server

(WINS) server.

If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol

settings. Otherwise, proceed to step 11.

5. Select [IPv4 - IP Address], and then [Change Settings].

6. Use the keypad on the screen to enter the IP Address for the machine in the

format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select

[Save].

7. Select [IPv4 – Subnet Mask], and then [Change Settings].

8. Using the same method as in step 6, enter the Subnet Mask.

9. Select [IPv4 – Gateway Address], and then [Change Settings].

NOTE: If you do not wish to set the gateway address, leave this field blank.

10. Using the same method as in step 6, enter the Gateway Address.

11. To enable IPv4 – IP Filtering, use CentreWare Internet Services to register the IP

addresses that will not be allowed to access the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: If you enable IP Filtering at the machine user interface without first configuring

it through Internet Services, then you will not be able to access the machine’s Internet

Services web page or print to the machine.

12. When you have finished establishing TCP/IP, select [Close] on the [Protocol

Settings] screen.

When [IPv6 Mode] or [Dual Stack] is selected

1. In [Connectivity & Network Setup], select [Protocol Settings].

2. Under [TCP/IP - IP Mode], select [IPv6 Mode], or [Dual Stack].

3. Set [IPv6 Address Manual Configuration].

NOTE: Select [Enabled] when the machine is connected to a network on which IPv6

stateless address autoconfiguration is disabled, or when you want to set a static IPv6

address.

If you selected [Enabled] in step 3, proceed to step 4. Otherwise, proceed to step 10.

4. Select [IPv6 – Manual IP Address Setup], and then [Change Settings].

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 235 236

Pas de commentaire

Xerox 7232 Manuel d'utilisateur Page 118