Xerox DOCUMATE 252 Manuel d'utilisateur télécharger pdf (Page 20)

DocuMate 252 Scanner User’s Guide 15

Installation

3. Turn on the power switch, located on the back of the scanner to

the left of the power port.

The status light comes on and flashes indicating that the

scanner is receiving power.

If you are using Windows XP and have plugged the USB cable

into a USB 1.1 port, an information bubble may open explaining

that “A HI-SPEED USB device is plugged into a non-HI-SPEED

USB hub”. Plug the USB cable into a USB 2.0 port (if available)

or just disregard the message. If you leave it plugged into the

USB 1.1 port, your scanner may scan a bit slower than the 25

pages per minute, and 50 images per minute available with a

USB 2.0 port.

Your computer then recognizes that a scanner has been

plugged into the USB port and automatically loads the

appropriate software to run the scanner.

Do not proceed until you receive a message that your computer

has found the new hardware, or updated the driver database. If

your computer is running Windows XP, you will see the

following message.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 132 133

Pas de commentaire

Xerox DOCUMATE 252 Manuel d'utilisateur Page 20