Xerox Phaser 6110MFP Manuel d'utilisateur Page 47

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 104
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 46
9.7 <
Maintenance>
7 Holding the handles on the new imaging unit, push the imaging unit
until it sounds ‘click’ into the machine.
8 Remove four dummy caps which are on the toner cartridge
entrances of the imaging unit. When you remove the dummy cap
from the cartridge, lift the handle up and pull it out.
Caution
If you force the dummy caps too much, it may cause a problem.
9 Insert the toner cartridges and waste toner container into their
corresponding slots until they click into place.
10 Close the front cover firmly.
11 Turn the machine on.
Caution
If the front cover is not completely closed, the machine will not
operate.
Tip
After rebooting, your machine will automatically reset the
counter for the imaging unit.
If the installation is completed properly, a guide report is
printed out automatically. Wait for about 1.5 minutes for the
machine to get ready.
Caution
If there is a grinding sound, re-install the imaging unit. The
imaging unit is not properly installed.
Vue de la page 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 103 104

Commentaires sur ces manuels

Pas de commentaire