Xerox STACKER 8855/721P Manuel d'utilisateur

THE DOCUMENT COMPANYXEROX8855/721P StackerOperator ManualXerox Wide Format Solutions701P39432

8Stacker RelocationThe stacker cannot be moved except by a DRC rigger.To ensure that the stacker operates reliably after moving it to a newlocation, c

9Technical DataDimensions: Width: 34” (864mm)57.5” (1461mm) w/paper supports extended.Depth: 41” (1041mm)Height: 28.5” (724mm)Weight: 108 lbs. (4

Prepared by:Global Knowledge and LanguagesServices780 Salt RoadWebster, New York 14580Copyright© 2003 by Xerox Corporation.Allrights reserved. XEROX

1Table of ContentsIt’s Illegal ... 2FCC Compliance ...

2It’s IllegalIn the USAIt is against U.S. law to copy copyrighted material without permissionof the copyright owner unless the copying falls within th

3Introduction to Your StackerCongratulations on acquiring your new Stacker.This User Guide provides information that is needed to operate theStacker.T

4Safety NotesYour stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, andc

5Safety Notes (continued)UNPLUG this stacker from the wall outlet and refer servicing toqualified service personnel under the following conditions:-

6Identifying the Parts on the StackerUpper Panel AssemblyStacker UnitMedia SupportsFrame AssemblyRelease HandleThumb ScrewsInletPower IndicatorLightPo

7Location of the Stacker Serial NumberIn order to locate the serial number of your stacker, you must firstpush down the release lever and slide the st